SATO CL4NX Operator's Manual page 80

4 Operation and Configuration
GAP Slice Level
Printing > Advanced > Calibrate > GAP Slice Level
Set the Gap sensor slice level.
The setting procedures are as follows:
1. Use the following formula to calculate the slice level.
[(High level - Low level) x 0.3 + Low level = slice level]
2. Select the GAP Slice Level in the Calibrate menu and press the
button.
/
3. Press the
the Slice level to the level calculated in step 1.
4. Press the right soft button to confirm the value.
Note:
If you set the Slice Level to 0.0 (V), the printer sets the slice level automat-
ically.
78
CL4NX Operator Manual
arrow buttons to change the Slice level value. Set