Eject Cut; Darkness Range - SATO CL4NX Operator's Manual

4 Operation and Configuration

Eject Cut

Printing > Eject Cut
Set the Eject cut motion for the last printed media. Cut the last media after
the specified timing.
Shows only when you have selected Cut & Print in the Print Mode menu.
The setting range is 0 to 5 (sec).

Darkness Range

Printing > Darkness Range
The darkness range affects the print darkness.
The options are as follows:
A, B, C, D, E, F
*Usually use A. You can also select B to F but the print darkness does not
change.
Darkness
Printing > Darkness
Specify the print darkness from ten steps.
The setting range is 1 to 10. 1 is the lightest and 10 is the darkest.
To further fine tune the print darkness, set the items in Printing >
Advanced > Adjustments > Darkness Adjust.
73
CL4NX Operator Manual