Paper End - SATO CL4NX Operator's Manual

4 Operation and Configuration

Paper End

Printing > Advanced > Paper End
Select the sensor for sensing the paper end.
The options are as follows:
• Using I-mark: Use the I-mark sensor (reflective type) to sense the
paper end.
• Using Gap: Use the Gap sensor (transmissive type) to sense the paper
end.
Head Base Position
Printing > Advanced > Head Base Position
Set the position used for the base reference point for printing.
The options are as follows:
• Standard: Print with a standard base reference point.
• Left-justify: Move the base reference point 2 mm (0.08") to the left
(when you face the printer).
Note:
If you have made any changes, power on the printer again.
Prioritize
Printing > Advanced > Prioritize
For printer configuration, set whether to prioritize the setting through the
printer or prioritize the setting through the command.
The options are as follows:
• Commands: Prioritize the setting through the command.
• Settings: Prioritize the setting through the printer.
Reprint
Printing > Advanced > Reprint
Enable or disable the reprint function.
The options are as follows:
• Enabled: Enable the reprint function.
• Disabled: Disable the reprint function.
If you have selected Enabled in Reprint, you can press the right soft but-
ton (Reprint) on the online screen to print the previous data again.
Note:
The previous data will be lost if you power off the printer.
84
CL4NX Operator Manual