Auto Measure; Ribbon Near End - SATO CL4NX Operator's Manual

4 Operation and Configuration

Auto Measure

Printing > Auto Measure
The printer automatically measures the length of the media.
The measured length of the media will be automatically saved in Label
Length.
Available when you have selected Gap or I-Mark in the Sensor Type
menu.
The setting procedures of the label length using the Auto Measure function
are as follows:
1. Load the media.
2. Set Auto Measure to Enabled.
3. Press the
screen.
4. Open the print head. (Head Open error occurs)
5. Close the print head. (Return to offline screen)
6. When you press the
and measures the label length.
7. The measured label length will be saved in Label Length.
Note:
When you have set Auto Measure to Enabled, this function executes
when the printer powers on.
Ribbon
Printing > Ribbon
Set whether to print using a ribbon or direct thermal paper.
The options are as follows:
• Use Ribbon: Print with a ribbon.
• Direct Thermal: Print with direct thermal paper.

Ribbon Near End

Printing > Ribbon Near End
Show or do not show the warning icon when the ribbon is about to run out.
The options are as follows:
• Enabled: Show the warning icon.
• Disabled: Do not show the warning icon.
Note:
The warning icon shows in the status bar on the upper part of the screen.
70
CL4NX Operator Manual
button or the button to show the online or offline
button, the printer feeds two pieces of label