5 Cleaning and Performing Printer Adjustments
5.2 Maintenance of the Print Head and Platen
Roller
Maintenance should be performed at the following regular intervals:
• After you print one media roll or print media for one hundred and fifty meters.
Use the cleaning kit to clean these parts:
• Print head
• Media sensors
• After you print six media rolls or print media for nine hundred meters.
Use the cleaning sheet to clean these parts:
• Print head
Use the cleaning kit to clean these parts:
• Media guide
• Media route
Note
The above maintenance intervals are only for reference. Perform the cleaning when necessary.
5.2.1
Maintenance using the Cleaning Kit
The maintenance procedures using the cleaning kit are as follows:
Note
For details of the cleaning kit, refer to the manual attached to the cleaning kit.
1
Make sure that the printer is in power off
mode, then disconnect the power cord
from the AC outlet.
2
Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.
176
CL4NX Operator Manual
• Platen roller
• Media guide
• Platen roller
• Feed roller
• Ribbon route