SATO CL4NX Operator's Manual page 84

4 Operation and Configuration
Offset
Printing > Advanced > Adjustments > Offset
Correct the offset position.
Offset position refers to the tear-off position, cut position and dispense
stop position.
Set the offset value using '+' to move the stop position opposite the feed
direction and '-' to move the stop position in the feed direction.
The setting range is as follows:
The setting range varies depending on the print resolution of the printer.
• 203 dpi: -30 to 0 to 30 dot
• 305 dpi: -45 to 0 to 45 dot
• 609 dpi: -90 to 0 to 90 dot
Pitch
Printing > Advanced > Adjustments > Pitch
Offset the print position in the vertical direction.
Set the offset value using '+' to move the print position opposite the feed
direction and '-' to move the print position in the feed direction.
The setting range is as follows:
The setting range varies depending on the print resolution of the printer.
• 203 dpi: -30 to 0 to 30 dot
• 305 dpi: -45 to 0 to 45 dot
• 609 dpi: -90 to 0 to 90 dot
Darkness Adjust
Printing > Advanced > Adjustments > Darkness Adjust
Fine tune the print darkness.
The setting range is 0 to 99.
0 is the lightest and 99 is the darkest.
Refer to Darkness
82
CL4NX Operator Manual
in Printing > Darkness.