Printing Rfid Tag Errors - SATO CL4NX Operator's Manual

7 Appendix
7.5.1

Printing RFID Tag Errors

If the recorded data on a tag is incomplete due to writing on a defective tag, the printer will print an RFID
tag error to the defective media. This function is to prevent the distribution of defective media with a tag
error.
When an RFID tag error occurs, the printer prints a slash and the error message, such as "WRITE TAG
ERROR" or "TAG NOT FOUND". The position to print the message and the slash is set using the
specified media size command <A1>.
For a write error such as "WRITE TAG ERROR", the printer continues to print the first sixteen bytes of
the write data. If there is not enough space, the printer prints the slash only. But before printing the error
message, the printer will delete the dump print data to make space.
The diagram below shows the message printed on the position based on the media size specified by the
normal print.
The dump is printed for the first sixteen
bytes of data.
The dump is printed for the first sixteen
bytes of data.
*(0,0): The origin of the range specified by the media size command <A1>
228
CL4NX Operator Manual
WRITE TAG ERROR in RFID write
command
Other than the write error, the printer
prints [PROTECT TAG ERROR] when you
try to write to a locked tag.
(0, 0)
TAG NOT FOUND error in RFID
write command
(0, 0)
Read error in UID/EPC/IDm
print command <TU> or TAG
NOT FOUND error
(0, 0)
Dotted line shows the range specified with
media size command <A1>.
When a character overlaps
with the slash, the character
will inverse from black to white.
Dotted line shows the range specified with
media size command <A1>.