SATO CL4NX Operator's Manual page 113

Traps
Interface > Network > Services > SNMP > Traps
Set the Traps function.
The setting items are as follows:
1 Enable
2 SNMP Version
3 IP Version
4 Destinations
5 Destination 1
6 Destination 2
7 Destination 3
8 Community
9 User
10 Engine ID
11 Security
12 Authentication
Protocol
13 Authentication
Passphrase
14 Privacy Protocol
15 Privacy Pass-
phrase
Use the Traps function.
Set the SNMP version.
Set the IP version.
Set the number of the Traps Destinations.
Set the address of the Traps Destinations.
Set the address of the Traps Destinations.
*Shows only if you have selected 2 or 3 in the
Destination menu.
Set the address of the Traps Destinations.
*Shows only if you have selected 3 in the Des-
tination menu.
Set the Traps community name.
*Shows only if you have selected 1 or 2c in the
SNMP Version menu.
Set the Traps user name.
*Shows only if you have selected 3 in the
SNMP Version menu.
Set the engine ID.
*Shows only if you have selected 3 in the
SNMP Version menu.
Set the security level.
*Shows only if you have selected 3 in the
SNMP Version menu.
Set the authentication protocol.
*Shows only if you have selected Authentica-
tion or Privacy in the Security menu.
Set the authentication passphrase.
*Shows only if you have selected Authentica-
tion or Privacy in the Security menu.
Set the authentication privacy protocol.
*Shows only if you have selected Privacy in
the Security menu.
Set the authentication privacy passphrase.
*Shows only if you have selected Privacy in
the Security menu.
4 Operation and Configuration
CL4NX Operator Manual
111