SATO CL4NX Operator's Manual page 125

External I/O
Interface > External I/O
Use the external (EXT) terminal as an interface between the host and the
printer.
The setting items are as follows:
1 Enable
2 Signals
3 EXT I/O Re-print
Enable
Interface > External I/O > Enable
Enable or disable the external terminal.
The options are as follows:
• Enabled: Enable the external signal (EXT) function.
• Disabled: Disable the external signal (EXT) function.
Signals
Interface > External I/O > Signals
Set the external signal.
Shows only if you have selected Enabled in the Enable menu.
The setting items are as follows:
1 EXT 9PIN
2 EXT Mode
3 Inputs
4 Outputs
Enable or disable the external terminal.
Set the external signal.
*Shows only if you have selected Enabled in
the Enable menu.
Set the reprint function that uses the external
terminal.
Set the output signal of the EXT 9PIN.
Set the mode of the external signal.
Set the input pin No. of the Signal Print Start/
Signal Reprint.
Set the output pin No. of the signal.
4 Operation and Configuration
CL4NX Operator Manual
123