SATO CL4NX Operator's Manual page 229

10
Adjust the position of the RFID antenna. Rotate the dial  to align the pointer  with
the media being used.
When the Antenna Pitch is set to Standard in the Interface > RFID menu, adjust the physical position of
the antenna according to the settings required for the specific media and inlay used. Refer to the
"Antenna Position" of the UHF Inlay Placement & Configuration Table in the CL4NX UHF Inlay
Configuration Guide.
11
Load the media and ribbon.
Refer to Section 3.2 Loading the Ribbon
12
Confirm the operation by printing/encoding a media.
Make sure that you read the data and check that it is correctly encoded.
4
and Section 3.5 Loading Media
7 Appendix
3
for details.
CL4NX Operator Manual
227