SATO CL4NX Operator's Manual page 82

4 Operation and Configuration
I-Mark Slice Level
Printing > Advanced > Calibrate > I-Mark Slice Level
Set the I-mark sensor slice level.
The setting procedures are as follows:
1. Use the following formula to calculate the slice level.
[(High level - Low level) x 0.7 + Low level = slice level]
2. Select the I-Mark Slice Level in the Calibrate menu and press the
button.
/
3. Press the
the Slice level to the slice level calculated in step 1.
4. Press the right soft button to confirm the value.
Note:
If you set the Slice Level to 0.0 (V), the printer sets the level automatically.
Head Check
Printing > Advanced > Head Check
Automatically check if there is a filament disconnection of the print head.
The options are as follows:
• Off: Head Check disabled.
• All: Check the entire print area.
• Barcode: Check only the area for printing a barcode. Head check is not
applicable for barcodes printed as graphic data.
Caution:
Head check is a reference for checking filament disconnection of the print
head. This function does not guarantee barcode readability.
Head Check Mode
Printing > Advanced > Head Check Mode
Set the method for head check.
Shows only if you have selected All or Barcode in the Head Check menu.
The options are as follows:
• Always: Perform the head check for every item.
• After Batch: The head check occurs before starting to print and when
printing is stopped. If backfeed is applicable, the head check occurs
before starting to print, when stopping to print and during the backfeed.
• Every Page: Perform the head check for each specified number of
media.
80
CL4NX Operator Manual
arrow buttons to change the Slice level value. Set