Bru-Sf10 Hd Optical Multiplex Unit (Not Supplied); Power Switch - Sony BRC-Z330 Operating Instructions Manual

Y TALLY/CONTACT selector
Select the function of the TALLY/CONTACT
connector.
TALLY: The tally lamp of the camera selected
with the connected switcher lights.
CONTACT: The contact output corresponding to
the camera address selected with the Remote
Control Unit is short-circuited against the
connected switcher.
CONTACT (TALLY): The contact output
corresponding to the camera address selected with
the Remote Control Unit is short-circuited against
the connected switcher and the tally lamp of the
camera selected with the Remote Control Unit
lights.
Notes
• Change the setting of the selector before you turn
on the power for the Remote Control Unit.
Otherwise, the setting is not effective.
• For more details on the functions of the TALLY/
CONTACT selector, refer to the Operating
Instructions of the RM-BR300.
wh DC IN 12V connector
Connect the supplied AC power adaptor.
wj DIP switches (bottom)
Switch 1 (RS-232C/RS-422 selector)
Set to ON for RS-422, or OFF for RS-232C.
Switch 2 (Communication baud rate selector)
Set to ON for 38400 bps, or OFF for 9600 bps.
Switch 3 (BRIGHT control function selector)
Set to ON for IRIS and GAIN adjustments, or OFF
for IRIS adjustment only.
Note
Set the DIP switches before you turn on the power
of the Remote Control Unit. Otherwise, the setting
is not effective.
wk ON/OFF switch
Press this switch to turn on/off the Remote Control
Unit.
BRU-SF10 HD Optical Multiplex
Unit (not supplied)
Front
1 2 3 4 5
ON/STANDBY
LINK
ALARM
DATA MIX SD
OFF ON
8
A Power switch
Turns on/off the power of this unit.Turn on the
power of the BRC-Z330 camera before you turn on
this unit.
B Power indicator
Off: The unit's power switch is turned off.
Lit orange: The unit is starting up or in sleep mode.
Lit green: The unit is in normal operation.
C LINK indicator
Lit green: The optical fiber connection between the
unit and the camera is normal. (The indicator
lights green after the system starts up.)
Lit red: Check for the following.
• The BRU-SF10 is not properly connected to
the camera via optical fiber cable. Check the
connections, and restart the unit.
• Image frequency settings for the camera and
the BRU-SF10 are different. Check the
settings after turning off the power, and then
restart the unit.
• The camera may be unable to start properly
due to the AC adapter being improperly
connected to the DC IN connector on the
camera. Check that the camera is turned on.
D ALARM indicator
Lit red: Check for the following.
• The BRU-SF10 is not properly connected to
the camera via optical fiber cable. Check the
connections, and restart the unit.
• Image frequency settings for the camera and
the BRU-SF10 are different. Check the
settings after turning off the power, and then
restart the unit.
• The camera may be unable to start properly
due to the AC adapter being improperly
connected to the DC IN connector on the
camera. Check that the camera is turned on.
6
1 2 3 4 5 6 7
7
1080i 59.94 RS232C 9600bps
720p 50 RS422 38400bps
HD OPTICAL MULTIPLEX UNIT
Location and Function of Parts
25