Specifying The Initial Settings - Muratec MFX-1450 User Manual

Specifying the initial settings

If you press <Reset> durng the ntal setup, your machne wll return to the
standby mode. You can save the settngs you have made by selectng [Enter] as
shown below.
1
2
3
4
5
1-24 u i
SEr
DA7-909H0-60.indb 24
Press <Settng> on the control panel.
Press [User Install].
The user nstall lst s dsplayed.
Set the desred tem. (See page 1-25 to 1-30)
After settng all the tems, press <Reset> to return to the standby mode.
Prnt out the "Fax Settngs Lst" to nsure that your settngs are correct. (See
page 10-2.)
nStall
2007/04/26 20:13:03