Reflect Between-Clients (Mbgp Address Family View) - HP 3600 v2 Series Command Reference Manual

route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters.
Using a routing policy can set preferences for the routes that match it. As for the unmatched routes, the
default preferences are adopted.
Description
Use preference to configure preferences for external, internal, and local routes.
Use undo preference to restore the default.
The default preference values of external, internal and local BGP routes are 255, 255, and 130,
respectively.
Examples
# In IPv4 MBGP address family view, configure preferences for eBGP, iBGP, and local IPv4 MBGP routes
as 20, 20, and 200.
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] preference 20 20 200

reflect between-clients (MBGP address family view)

Syntax
reflect between-clients
undo reflect between-clients
View
IPv4 MBGP address family view
Default level
2: System level
Parameters
None
Description
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a route
reflector are fully meshed, you must disable route reflection between clients to reduce routing costs.
Related commands: reflector cluster-id and peer reflect-client.
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] undo reflect between-clients
248