Pim Triggered-Hello-Delay; Register-Policy (Pim View) - HP 6125XLG Command Reference Manual

Usage guidelines
You can set the interval for sending the join/prune messages in PIM view or interface view. The
configurations made in PIM view are effective on all interfaces, and the configurations made in interface
view are effective on only the current interface. If you set the interval in both PIM view and interface view,
the configuration in interface view always takes precedence.
Examples
# Set the interval for sending the join/prune messages to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer join-prune 80
Related commands
timer join-prune (PIM view)

pim triggered-hello-delay

Use pim triggered-hello-delay to set the maximum delay between two hello messages.
Use undo pim triggered-hello-delay to restore the default.
Syntax
pim triggered-hello-delay delay
undo pim triggered-hello-delay
Default
The maximum delay between two hello messages is 5 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
delay: Sets the maximum delay (in seconds) between two hello messages, in the range of 1 to 60.
Examples
# Set the maximum delay between two hello messages to 3 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim triggered-hello-delay 3

register-policy (PIM view)

Use register-policy to configure an ACL rule to filter register messages.
Use undo register-policy to remove the configured register filtering rule.
Syntax
register-policy acl-number
86