Configuring The Boot Drive; Solid State Drive (Ssd) Backplane; Removing The Ssd Backplane - Dell E01B002 Owner's Manual

Configuring the boot drive

The drive or device from which the system boots is determined by the boot order specified in the System Setup.

Solid State Drive (SSD) backplane

The SSD backplane of your system allows you to use hot-swappable SSDs. You can remove and install the SSD backplane.

Removing the SSD backplane

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
CAUTION: To prevent damage to the SSDs and the SSD backplane, you must remove the SSD carriers from the
sled before removing the SSD backplane.
CAUTION: You must note the bay number of each SSD and temporarily label them before removal so that you
can reinstall them into their original bays.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the SSD carrier(s).
4. Keep the Phillips #2 screwdriver ready.
Steps
1. Loosen the two captive screws on the backplane touch points that secure the SSD backplane to the SSD cage.
2. Holding the backplane at the touch points, lift the SSD backplane till it disengages from the connector on the system board.
3. Lift the backplane away from the SSD cage.
Figure 39. Removing the SSD backplane
1. SSD backplane connector on system board 2. captive screw (2)
Installing and removing sled components 95