Dell Force10 S4810P Configuration Manual page 554

Note: After you configure a static IPv6 route (
(specified in the
ipv6 route
command output.
route
Command Syntax
ipv6 route
{slot/port} forwarding
router tag
554
| IPv6 Routing
command) on a neighbor's interface, the IPv6 neighbor is not displayed in the
Command Mode
CONFIGURATION
prefix type
command) and configure the forwarding router's address
ipv6 route
Purpose
Set up IPv6 static routes
: IPv6 route prefix
prefix
type {slot/port}:
forwarding router:
route tag
tag:
Enter the keyword
interface and slot/port information:
• For a 10/100/1000 Ethernet interface, enter the keyword
GigabitEthernet
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
• For a loopback interface, enter the keyword
followed by the loopback number
• For a linecard interface, enter the keyword
followed by the slot number
• For a port-channel interface, enter the keyword
port-channel
• For a VLAN interface, enter the keyword
by the VLAN ID
• For a Null interface, enter the keyword
the Null interface number
interface type and slot/port
forwarding router's address
followed by the type of
interface
followed by the slot/port information.
followed by the slot/port information.
followed by the slot/port
followed by the slot/port information.
followed by the port-channel number
show ipv6
loopback
linecard
followed
vlan
followed by
null