Dell Force10 S4810P Configuration Manual page 589

Configure the prefix list in the PREFIX LIST mode prior to assigning it to the IS-IS process. For
configuration information on prefix lists, see
IPv4 routes
Use the following commands in ROUTER ISIS mode to apply prefix lists to incoming or outgoing IPv4
routes.
Note: These commands apply to IPv4 IS-IS only. Use the ADDRESS-FAMILY IPV6 mode shown later to
apply prefix lists to IPv6 routes
Command Syntax
distribute-list prefix-list-name in
distribute-list prefix-list-name out
| |
connected
as-number
]
static
distribute-list redistributed-override in
[ ]
interface
[
bgp
| |
ospf process-id rip
Chapter 6, Access Control Lists
Command Mode Purpose
ROUTER ISIS Apply a configured prefix list to all incoming
IPv4 IS-IS routes.
Enter the type of interface and slot/port
information:
•
•
•
•
•
•
ROUTER ISIS Apply a configured prefix list to all outgoing
IPv4 IS-IS routes. You can configure one of
the optional parameters:
•
•
•
•
•
ROUTER ISIS Deny RTM download for pre-existing
redistributed IPv4 routes
Intermediate System to Intermediate System | 589
(ACLs).
For a 1-Gigabit Ethernet interface, enter
the keyword
GigabitEthernet
the slot/port information.
For the Loopback interface on the RPM,
enter the keyword
loopback
number from 0 to 16383.
For a port channel, enter the keyword
followed by a number from
port-channel
1 to 255 for TeraScale and ExaScale, 1 to
32 for EtherScale.
For a SONET interface, enter the keyword
followed by slot/port information.
sonet
For a 10-Gigabit Ethernet interface, enter
the keyword
TenGigabitEthernet
by the slot/port information.
For a VLAN, enter the keyword
followed by a number from 1 to 4094.
E-Series ExaScale platforms support
4094 VLANs with FTOS version
8.2.1.0 and later. Earlier ExaScale
supports 2094 VLANS.
: for directly connected routes.
connected
for OSPF routes only.
ospf process-id:
: for RIP routes only.
rip
: for user-configured routes.
static
: for BGP routes only
bgp
followed by
followed by a
followed
vlan