Ipv6 Routes - Dell Force10 S4810P Configuration Manual

IPv6 routes

Use these commands in ADDRESS-FAMILY IPV6 mode to apply prefix lists to incoming or outgoing
IPv6 routes. =
These commands apply to IPv6 IS-IS only. Use the
Note:
prefix lists to IPv4 routes.
Command Syntax
dis
tribute-list prefix-list-name in
distribute-list
prefix-list-name out [bgp
|
connected
as-number
]
static
distribute-list redistributed-override in
590
| Intermediate System to Intermediate System
[ ]
interface
| | |
ospf process-id rip
ROUTER ISIS
Command Mode Purpose
ROUTER ISIS-AF Apply a configured prefix list to all incoming
IPV6 IPv6 IS-IS routes.
Enter the type of interface and slot/port
information:
• For a 1-Gigabit Ethernet interface, enter
the keyword
the slot/port information.
• For the Loopback interface on the RPM,
enter the keyword
number from 0 to 16383.
• For a port channel, enter the keyword
port-channel
1 to 255 for TeraScale, 1 to 32 for
EtherScale.
• For a SONET interface, enter the keyword
sonet
• For a 10-Gigabit Ethernet interface, enter
the keyword
by the slot/port information.
• For a VLAN, enter the keyword
followed by a number from 1 to 4094.
E-Series ExaScale platforms support
4094 VLANs with FTOS version
8.2.1.0 and later. Earlier ExaScale
supports 2094 VLANS.
ROUTER ISIS-AF Apply a configured prefix list to all outgoing
IPV6 IPv6 IS-IS routes. You can configure one of
the optional parameters:
•
connected
•
ospf process-id:
•
rip
•
static
•
bgp
ROUTER ISIS-AF Deny RTM download for pre-existing
IPV6 redistributed IPv6 routes
mode previously shown to apply
GigabitEthernet
followed by a
loopback
followed by a number from
followed by slot/port information.
TenGigabitEthernet
: for directly connected routes.
for OSPF routes only.
: for RIP routes only.
: for user-configured routes.
: for BGP routes only
followed by
followed
vlan