Related Configuration Tasks; Enabling Gvrp Globally; Enabling Gvrp On A Layer 2 Interface - Dell Force10 S4810P Configuration Manual

Basic GVRP configuration is a 2-step process:
1. Enabling GVRP
2. Enabling GVRP on a Layer 2

Related Configuration Tasks

• Configuring GVRP Registration
• Configuring a GARP Timer

Enabling GVRP Globally

Enable GVRP for the entire switch using the command
in the following example. Use the
FTOS(conf)#protocol gvrp
FTOS(config-gvrp)#no disable
FTOS(config-gvrp)#show config
!
protocol gvrp
no disable
FTOS(config-gvrp)#

Enabling GVRP on a Layer 2 Interface

Enable GVRP on a Layer 2 interface using the command
the following example. Use
configuration, as shown in the following example, or use the
EXEC Privilege mode.
FTOS(conf-if-gi-1/21)#switchport
FTOS(conf-if-gi-1/21)#gvrp enable
FTOS(conf-if-gi-1/21)#no shutdown
FTOS(conf-if-gi-1/21)#show config
!
interface GigabitEthernet 1/21
no ip address
switchport
gvrp enable
no shutdown
Globally.
Interface.
show gvrp brief
from the INTERFACE mode to inspect the interface
show config
in CONFIGURATION mode, as shown
gvrp enable
command to inspect the global configuration.
in INTERFACE mode, as shown in
gvrp enable
show gvrp interface
GARP VLAN Registration Protocol (GVRP) | 435
command in EXEC or