Dell Force10 S4810P Configuration Manual page 205

Figure 9-19. Command example: show config (creating peer-group)
FTOS(conf-router_bgp)#neighbor zanzibar peer-group
FTOS(conf-router_bgp)#show conf
!
router bgp 45
bgp fast-external-fallover
bgp log-neighbor-changes
neighbor zanzibar peer-group
neighbor zanzibar shutdown
neighbor 10.1.1.1 remote-as 65535
neighbor 10.1.1.1 shutdown
neighbor 10.14.8.60 remote-as 18505
neighbor 10.14.8.60 no shutdown
FTOS(conf-router_bgp)#
Use the
neighbor peer-group-name no shutdown
mode to enable a peer group.
Figure 9-20. Command example: show config (peer-group enabled
FTOS(conf-router_bgp)#neighbor zanzibar no shutdown
FTOS(conf-router_bgp)#show config
!
router bgp 45
bgp fast-external-fallover
bgp log-neighbor-changes
neighbor zanzibar peer-group
neighbor zanzibar no shutdown
neighbor 10.1.1.1 remote-as 65535
neighbor 10.1.1.1 shutdown
neighbor 10.14.8.60 remote-as 18505
neighbor 10.14.8.60 no shutdown
FTOS(conf-router_bgp)#
To disable a peer group,
CONFIGURATION ROUTER BGP mode. The configuration of the peer group is maintained, but it is not
applied to the peer group members. When you disable a peer group, all the peers within the peer group that
are in ESTABLISHED state are moved to IDLE state.
Use the
show ip bgp peer-group
peer groups.
use the
neighbor peer-group-name shutdown
command in EXEC Privilege mode
Configuring neighbor zanzibar
command in the CONFIGURATION ROUTER BGP
Enabling neighbor zanzibar
command in the
(Figure 9-21) to view the status of
Border Gateway Protocol | 205