Dell Force10 S4810P Configuration Manual page 180

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

Note: In 8.3.11.4, the bgp bestpath as-path multipath-relax command is disabled by default, preventing

BGP from load-balancing a learned route across two or more eBGP peers. To enable load-balancing across

different eBGP peers, enable the bgp bestpath as-path multipath-relax command.

A system error will result if the bgp bestpath as-path ignore command and the bgp bestpath as-path

multipath-relax command are configured at the same time. Only enable one command at a time.

illustration details the path selection criteria.

Figure 9-4. BGP Best Path Selection

Border Gateway Protocol

illustrates the decisions BGP goes through to select the best path. The list following the

Troubleshooting