Dell Force10 S4810P Configuration Manual page 329

Step Task
3 Configure the DCBx version used on the interface, where:
configures the port to operate using the DCBx version
auto
received from a peer.
• configures the port to use CEE (Intel 1.01).
cee
• configures the port to use Cisco-Intel-Nuova
cin
(DCBx 1.0).
• configures the port to use IEEE 802.1Qaz
ieee-v2.5
(Draft 2.5).
Default: Auto.
4 Configure the DCBx port role used by the interface to
exchange DCB information, where:
•
auto-upstream
configuration. The configuration source is elected from
auto-upstream ports.
•
auto-downstream
internally propagated DCB configuration from a
configuration source.
•
config-source
configuration source on the switch.
• configures the port to operate only on
manual
administer-configured DCB parameters. The port does
not accept a DCB configuration received from a peer or
a local configuration source.
Default: Manual.
5
On manual ports only:
Configure the PFC and ETS TLVs advertised to DCBx
peers, where:
• enables the advertisement of ETS
ets-conf
Configuration TLVs.
• enables the advertisement of ETS Recommend
ets-reco
TLVs.
• enables the advertisement of PFC TLVs.
pfc
Default: All PFC and ETS TLVs are advertised.
Note: You can configure the transmission of more than one
TLV type at a time; for example: advertise DCBx-tlv ets-conf
ets-reco. You can enable ETS recommend TLVs (ets-reco)
only if ETS configuration TLVs (ets-conf) are enabled. To
disable TLV transmission, use the no form of the command;
for example, no advertise DCBx-tlv pfc ets-reco.
configures the port to receive a peer
configures the port to accept the
configures the port to serve as the
Command
[no] DCBx version {auto |
cee | cin | ieee-v2.5}
[no] DCBx port-role
{config-source |
auto-downstream |
auto-upstream | manual}
[no] advertise DCBx-tlv
{ets-conf | ets-reco | pfc}
[ets-conf | ets-reco | pfc]
[ets-conf | ets-reco | pfc]
Data Center Bridging (DCB) | 329
Command Mode
PROTOCOL LLDP
PROTOCOL LLDP
PROTOCOL LLDP