Dell Force10 S4810P Configuration Manual page 790

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

The number of source ports FTOS allows within a port-pipe is equal to the number of physical ports in the

port-pipe (n). However, n number of ports may only have four different destination ports

Figure 36-2. Number of Monitoring Ports on the C-Series and S-Series

FTOS#show mon session

FTOS(conf)#mon ses 300

FTOS(conf-mon-sess-300)#source gig 0/17 destination gig 0/4 direction tx

% Error: Exceeding max MG ports for this MD port pipe.

FTOS(conf-mon-sess-300)#

FTOS(conf-mon-sess-300)#source gig 0/17 destination gig 0/1 direction tx

FTOS(conf-mon-sess-300)#do show mon session

FTOS(conf-mon-sess-300)#

different destinations (0/1, 0/2, 0/3, and 0/37). Now it is not possible for another source port from the same

port-pipe (for example, 0/17) to point to another new destination (for example, 0/4). If you attempt to

configure another destination,

that uses one of previously used destination ports, as shown in

Figure 36-3. Number of Monitoring Ports on the C-Series and S-Series

FTOS(conf)#mon ses 300

FTOS(conf-mon-sess-300)#source gig 0/17 destination gig 0/4 direction tx

% Error: Exceeding max MG ports for this MD port pipe.

FTOS(conf-mon-sess-300)#

FTOS(conf-mon-sess-300)#source gig 0/17 destination gig 0/1 direction tx

FTOS(conf-mon-sess-300)#do show mon session

four destination ports, new or used.

Port Monitoring

36-2, ports 0/13, 0/14, 0/15, and 0/16 all belong to the same port-pipe. They are pointing to four

36-4, 0/25 and 0/26 belong to Port-pipe 1. This port-pipe again has the same restriction of only

appears. However, you can configure another monitoring session

Troubleshooting