Dell Force10 S4810P Configuration Manual page 582

High-density, 1ru 48-port 10gbe switch
Hide thumbs Also See for Force10 S4810P:
Table of Contents

Advertisement

Command Syntax
graceful-restart restart-wait seconds
graceful-restart t1 {interval seconds |
retry-times value}
graceful-restart t2 {level-1 | level-2}
seconds
graceful-restart t3 {adjacency | manual
seconds}
582
|
Intermediate System to Intermediate System
Command Mode
Purpose
ROUTER-ISIS
Enable the Graceful Restart maximum wait time before
a restarting peer comes up.
Be sure to set the
router when implementing this command.
Range: 5-120 seconds
Default: 30 seconds
ROUTER-ISIS
Configure the time that the Graceful Restart timer T1
defines for a restarting router to use for each interface,
as an interval before regenerating Restart Request (an
IIH with RR bit set in Restart TLV) after waiting for an
acknowledgement.
interval
retry-times
restart request will be sent before the restarting router
gives up the graceful restart engagement with the
neighbor. (Range: 1-10 attempts, default: 1)
ROUTER-ISIS
Configure the time for Graceful Restart timer T2 that a
restarting router will use as the wait time for each
database to synchronize.
level-1, level-2
which the wait interval applies.
Range: 5-120 seconds
Default: 30 seconds
ROUTER-ISIS
Configure Graceful Restart timer T3 to set the time
used by the restarting router as an overall maximum
time to wait for database synchronization to complete.
adjacency
time value from its peer and adjusts its T3 value
accordingly if user has configured this option.
manual
restarting router should use.
Range: 50-120 seconds
Default: 30 seconds
Note: If this timer expires before the synchronization has completed,
the restarting router sends the overload bit in the LSP. The 'overload'
bit is an indication to the receiving router that database synchronization
did not complete at the restarting router.
timer to adjacency on the restarting
t3
: wait time (Range: 5-120, default: 5)
: number of times an unacknowledged
: identifies the database instance type to
: the restarting router receives the remaining
: allows you to specify a fixed value that the

Advertisement

Table of Contents
loading

Table of Contents