Show an IPv6 Interface
View the IPv6 configuration for a specific interface with the following command.
Command Syntax
show ipv6 interface
type {slot/port}
Figure 25-6
illustrates the
Figure 25-6. Command Example:
FTOS#show ipv6 interface gi 2/2
GigabitEthernet 2/2 is down, line protocol is down
IPV6 is enabled
Link Local address: fe80::201:e8ff:fe06:95a3
Global Unicast address(es):
3:4:5:6::8, subnet is 3::/24
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:8
ff02::1:ff06:95a3
MTU is 1500
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 1
ND reachable time is 30 seconds
ND advertised reachable time is 30 seconds
ND advertised retransmit interval is 30 seconds
ND router advertisements are sent every 200 seconds
ND router advertisements live for 1800 seconds
Command Mode
EXEC
command output.
show ipv6 interface
show ipv6 interface
Purpose
Show the currently running configuration for the specified
interface
Enter the keyword
interface
and slot/port information:
•
For all brief summary of IPv6 status and configuration,
enter the keyword
brief
•
For all IPv6 configured interfaces, enter the keyword
configured
.
•
For a 10/100/1000 Ethernet interface, enter the keyword
followed by the slot/port information.
GigabitEthernet
•
For a Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
GigabitEthernet
•
For a 10 Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
TenGigabitEthernet
•
For a 40-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
fortyGigE
•
For a loopback interface, enter the keyword
followed by the loopback number
•
For a linecard interface, enter the keyword
followed by the slot number
•
For a port-channel interface, enter the keyword
followed by the port-channel number
port-channel
•
For a VLAN interface, enter the keyword
the VLAN ID
followed by the type of interface
.
loopback
linecard
followed by
vlan
IPv6 Routing | 557