Dell Force10 S4810P Configuration Manual page 55

Task
Allow access to INTERFACE, LINE, ROUTE-MAP,
and/or ROUTER mode. Specify all keywords in the
command.
Allow access to a CONFIGURATION, INTERFACE,
LINE, ROUTE-MAP, and/or ROUTER mode command.
The configuration in the following example creates privilege level 3. This level:
• removes the
• moves the command
a minimum privilege level 3, which is the configured level for VTY 0
• allows access to CONFIGURATION mode with the
• allows access to INTERFACE and LINE modes are allowed with no commands
FTOS(conf)#do show run priv
!
privilege exec level 3 capture
privilege exec level 3 configure
privilege exec level 4 resequence
privilege exec level 3 capture bgp-pdu
privilege exec level 3 capture bgp-pdu max-buffer-size
privilege configure level 3 line
privilege configure level 3 interface
FTOS(conf)#do telnet 10.11.80.201
[telnet output omitted]
FTOS#show priv
Current privilege level is 3.
FTOS#?
capture
configure
disable
enable
exit
ip
monitor
mtrace
ping
quit
show
[output omitted]
FTOS#config
[output omitted]
FTOS(conf)#do show priv
Current privilege level is 3.
FTOS(conf)#?
command from EXEC mode by requiring a minimum of privilege level 4
resequence
capture bgp-pdu max-buffer-size
Capture packet
Configuring from terminal
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Global IP subcommands
Monitoring feature
Trace reverse multicast path from destination to source
Send echo messages
Exit from the EXEC
Show running system information
Command Syntax
privilege configure level level
{ | |
interface line route-map
} {
router
command-keyword
}
command-keyword
{ |
privilege configure interface
| | }
route-map router level level
{ ||...||
command command
from EXEC Privilege to EXEC mode by requiring
command
banner
Command Mode
CONFIGURATION
|
||...||
|
line
CONFIGURATION
}
Management | 55