Dell Force10 S4810P Configuration Manual page 948

Figure 46-2. Select a User-based Security Type
FTOS(conf)#snmp-server host 1.1.1.1 traps {oid tree} version 3 ?
auth
noauth
priv
FTOS(conf)#snmp-server host 1.1.1.1 traps {oid tree} version 3 noauth ?
WORD
To set up a user with view privileges only (no password or privacy privileges):
Task
Configure the user.
Configure an SNMP group.
Configure an SNMPv3 view.
To set up a user with password privileges only, use the following commands:
Task
Configure the user with an authorization
password
Configure an SNMP group.
Configure an SNMPv3 view.
To set up a user with password or privacy privileges:
Task
Configure an SNMP group.
Configure the user with a secure
authorization password and
privacy password.
Configure an SNMPv3 view.
948
| Simple Network Management Protocol (SNMP)
Use the SNMPv3 authNoPriv Security Level
Use the SNMPv3 noAuthNoPriv Security Level
Use the SNMPv3 authPriv Security Level
SNMPv3 user name
Command
snmp-server user name group-name 3 noauth
snmp-server group group-name 3 noauth auth
read name write name
snmp-server view view-name oid-tree
}
excluded
Note: To give a user read and write view privileges,
repeat this step for each privilege type.
Command
snmp-server user name group-name 3 noauth
auth md5 auth-password
snmp-server group groupname {oid-tree} auth
read name write name
snmp-server view view-name 3 noauth
}
excluded
Note: To give a user read and write privileges,
repeat this step for each privilege type.
Command
snmp-server group group-name {oid-tree} priv
read name write name
snmp-server user name group-name {oid-tree}
auth md5 auth-password priv des56 priv password
snmp-server view view-name oid-tree
}
excluded
Command Mode
CONFIGURATION
CONFIGURATION
{ | CONFIGURATION
included
Command Mode
CONFIGURATION
CONFIGURATION
{ | CONFIGURATION
included
Command Mode
CONFIGURATION
CONFIGURATION
{ | CONFIGURATION
included