Add Or Remove A Port Channel From A Vlan; Configure Minimum Oper Up Links In Port Channel - Dell Force10 S4810P Configuration Manual

Configure the minimum oper up links in a port channel (LAG)
You can configure the minimum links in a port channel (LAG) that must be in "oper up" status for the port
channel to be considered to be in "oper up" status. Use the following command in the INTERF ACE mode:
Command Syntax
minimum-links
number
The following text displays an example of configuring five minimum "oper up" links in a port channel.
FTOS#config t
FTOS(conf)#int po 1
FTOS(conf-if-po-1)#minimum-links 5
FTOS(conf-if-po-1)#

Add or remove a port channel from a VLAN

As with other interfaces, you can add Layer 2 port channel interfaces to VLANs. To add a port channel to a
VLAN, you must place the port channel in Layer 2 mode (by using the
To add a port channel to a VLAN, use either of the following commands:
Command Syntax
tagged port-channel
id number
untagged port-channel
id number
To remove a port channel from a VLAN, use either of the following commands:
Command Syntax
no tagged port-channel
id number
no untagged port-channel
To see which port channels are members of VLANs, enter the
mode.
Command Mode
INTERFACE
Command Mode
INTERFACE
VLAN
INTERFACE
VLAN
Command Mode
INTERFACE
VLAN
INTERFACE
id number
VLAN
Purpose
Enter the number of links in a LAG that must be in "oper
up" status.
Default: 1
switchport
Purpose
Add the port channel to the VLAN as a tagged
interface. An interface with tagging enabled can
belong to multiple VLANs.
Add the port channel to the VLAN as an untagged
interface. An interface without tagging enabled can
belong to only one VLAN.
Purpose
Remove the port channel with tagging enabled
from the VLAN.
Remove the port channel without tagging
enabled from the VLAN.
command in the EXEC Privilege
show vlan
command).
Interfaces | 489