Dell Force10 S4810P Configuration Manual page 97

To terminate the authentication process due to an unresponsive authentication server:
Step Task
1 Terminate the authentication process due to an
unresponsive authentication server.
The example below shows configuration information for a port for which the authenticator terminates the
authentication process for an unresponsive supplicant or server after 15 seconds.
FTOS(conf-if-Te-0/0)#dot1x port-control force-authorized
FTOS(conf-if-Te-0/0)#do show dot1x interface TenGigabitEthernet 0/0
802.1x information on Te 0/0:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Auth Type:
Auth PAE State:
Backend State:
Command Syntax
dot1x server-timeout seconds
Range: 1-300
Default: 30
Enable
FORCE_AUTHORIZED
UNAUTHORIZED
Disable
None
Disable
NONE
Disable
NONE
NONE
90 seconds
120 seconds
10
15 seconds
15 seconds
7200 seconds
10
SINGLE_HOST
Initialize
Initialize
Command Mode
INTERFACE
802.1X | 97