Additional Configuration - Dell Force10 S4810P Configuration Manual

Pre-configure a line card slot
You may also pre-configure an empty line card slot with a logical line card using the command
from CONFIGURATION mode. After creating the logical line card, you can configure the interfaces on
the line card as if it is present, as shown in the example below.
FTOS(conf)#do show linecard 0
-- Line card 0 --
Status
FTOS(conf)#int gig 0/0
% Error: No card configured in slot at "^" marker.
FTOS(conf)#linecard 0 E48VB
FTOS(conf)#do show linecard 0
-- Line card 0 --
Status
Required Type : E48VB - 48-port GE 10/100/1000Base-T line card with RJ45 interfaces and PoE (CB)
FTOS(conf)#int gig 0/0
FTOS(conf-if-gi-0/0)#
Replace a line card
If you are replacing a line card with a line card of the same type, you may replace the card without any

additional configuration.

If you are replacing a line card with a line card of a different type, remove the card and then remove the
existing line card configuration using the command
mismatch
Message 6 Line card Mismatch Error
%RPM0-P:CP %CHMGR-3-CARD_MISMATCH: Mismatch: line card 0 is type E48VB - type E48TB required
To clear this line card mismatch status and bring the line card online, specify the type of line card you
inserted using the command
%RPM0-P:CP %CHMGR-5-CARDDETECTED: Line card 0 present
%RPM0-P:CP %CHMGR-3-CARD_MISMATCH: Mismatch: line card 0 is type E48VB - type E48TB required
FTOS#show linecard
-- Line cards
Slot Status
---------------------------------------------------------------------------
0 type mismatch online
[output omitted]
FTOS(conf)#linecard 0 E48VB
Aug 6 14:25:22: %RPM0-P:CP %IFMGR-1-DEL_PORT: Removed port: Gi 0/0-47
FTOS(conf)#Aug 6 14:25:24: %RPM0-P:CP %CHMGR-5-LINECARDUP: Line card 0 is up
FTOS#show linecard
448
| High Availability
: not present
^
: not present
(Message 6) when you insert the new card, and the installed line card has a card mismatch status.
linecard
all
--
NxtBoot ReqTyp
E48TB
all
no linecard
, as shown in the example below.
CurTyp Version
E48VB 7-5-1-71
. If you do not, FTOS reports a card
Ports
48
linecard