Enable A Physical Interface - Dell Force10 S4810P Configuration Manual

no ip address
shutdown
!
interface GigabitEthernet 9/7
no ip address
shutdown
!
interface GigabitEthernet 9/8
no ip address
shutdown
!
interface GigabitEthernet 9/9
no ip address
shutdown

Enable a Physical Interface

After determining the type of physical interfaces available, the user may enter the INTERFACE mode by
entering the command
To enter the INTERFACE mode, use these commands in the following sequence, starting in the
CONFIGURATION mode:
Step Command Syntax
1
interface
2
no shutdown
To confirm that the interface is enabled, use the
the INTERFACE mode, use the
interface.
474
| Interfaces
interface interface slot/port
Command Mode
CONFIGURATION
interface
INTERFACE
exit
to enable and configure the interfaces.
Purpose
Enter the keyword interface followed by the type of interface
and slot/port information:
• For a 10/100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For the Management interface on the RPM, enter the
keyword ManagementEthernet followed by the slot/port
information.
• For a SONET interface, enter the keyword sonet followed
by slot/port information.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
Enter the no shutdown command to enable the interface. If the
interface is a SONET interface, enter the encap ppp command
to enable PPP encapsulation.
command in the INTERFACE mode. To leave
show config
command or command. The user can not delete a physical
end
fortyGigE