Configure Per-Vlan Spanning Tree Plus; Implementation Information; Related Configuration Tasks - Dell Force10 S4810P Configuration Manual

Table 38-1. FTOS Supported Spanning Tree Protocols
Dell Force10 Term
Multiple Spanning Tree Protocol
(MSTP)
Per-VLAN Spanning Tree Plus
(PVST+)

Implementation Information

• The FTOS implementation of PVST+ is based on IEEE Standard 802.1d.
• The FTOS implementation of PVST+ uses IEEE 802.1s costs as the default costs
implementations use IEEE 802.1d costs as the default costs if you are using Dell Force10 systems in a
multi-vendor network, verify that the costs are values you intended.
• You must allocate at least the default minimum amount of Layer 2 ACL CAM space when employing
PVST+ on the E-Series. See
• On the C-Series and S-Series, you can enable PVST+ on 254 VLANs. To set up VLANs, see
Chapter 53, Virtual LANs

Configure Per-VLAN Spanning Tree Plus

Configuring PVST+ is a four-step process:
1. Configure interfaces for Layer
2. Place the interfaces in VLANs.
3. Enable PVST+. See
4. Optionally, for load balancing, select a non-default bridge-priority for a VLAN. See page 807.

Related Configuration Tasks

• Modify Global PVST+ Parameters on page 809
• Modify Interface PVST+ Parameters on page 810
• Configure an EdgePort on page 811
• Flush MAC Addresses after a Topology Change on page 701
• Preventing Network Disruptions with BPDU Guard on page 1011
• SNMP Traps for Root Elections and Topology Changes on page 1016
• Configuring Spanning Trees as Hitless on page 1017
• PVST+ in Multi-vendor Networks on page 812
• PVST+ Extended System ID on page 812
• PVST+ Sample Configurations on page 813
806
| Per-VLAN Spanning Tree Plus (PVST+)
IEEE Specification
802.1s
Third Party
Configure Ingress Layer 2 ACL Sub-partitions on page
(VLAN).
2.
page 807.
(Table 38-2). Other
287.