Change Ospfv2 Parameters On Interfaces - Dell Force10 S4810P Configuration Manual

Figure 34-14 shows the convergence settings when fast-convergence is enabled and
settings when fast-convergence is disabled. These displays appear with the
Command Example: show ip ospf process-id (fast-convergence enabled )
Figure 34-14.
FTOS(conf-router_ospf-1)#fast-converge 2
FTOS(conf-router_ospf-1)#ex
FTOS(conf)#ex
FTOS#show ip ospf 1
Routing Process ospf 1 with ID 192.168.67.2
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 2
Min LSA origination 0 secs, Min LSA arrival 0 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0
Command example:
Figure 34-15.
FTOS#(conf-router_ospf-1)#no fast-converge
FTOS#(conf-router_ospf-1)#ex
FTOS#(conf)#ex
FTOS##show ip ospf 1
Routing Process ospf 1 with ID 192.168.67.2
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 5 secs, Min LSA arrival 1 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0

Change OSPFv2 parameters on interfaces

In FTOS, you can modify the OSPF settings on the interfaces. Some interface parameter values must be
consistent across all interfaces to avoid routing errors. For example, you must set the same time interval for
the hello packets on all routers in the OSPF network to prevent misconfiguration of OSPF neighbors.
process-id (fast-convergence disabled)
show ip ospf
Open Shortest Path First (OSPFv2 and OSPFv3) | 745
Figure 34-15
command.
show ip ospf
Fast-converge parameter
setting
LSA parameters
Fast-converge parameter
setting
LSA parameters
shows