Interface Configuration - Dell Force10 S4810P Configuration Manual

R1: ACTIVE Role
To establish a session:
Step Task
1 Enter interface mode
2 Assign an IP address to the interface if one is not already
assigned.
Verify that the session is established using the command
below.
R1(conf-if-gi-4/24)#do show bfd neighbors
* - Active session role
Ad Dn - Admin Down
C - CLI
I - ISIS
O - OSPF
R - Static Route (RTM)
LocalAddr
* 2.2.2.1
The example below for the command
BFD sessions.
R1(conf-if-gi-4/24)#do show bfd neighbors detail
Session Discriminator: 1
Neighbor Discriminator: 1
Local Addr: 2.2.2.1
Local MAC Addr: 00:01:e8:09:c3:e5
Remote Addr: 2.2.2.2
Remote MAC Addr: 00:01:e8:06:95:a2
Int: GigabitEthernet 4/24
State: Up
Configured parameters:
4/24
FTOS(config)# bfd enable
FTOS(config)# interface gigabitethernet 4/24
FTOS(conf-if-gi-2/1)# ip address 2.2.2.1/24
FTOS(conf-if-gi-2/1)# bfd neighbor 2.2.2.2
RemoteAddr Interface State Rx-int Tx-int Mult Clients
2.2.2.2 Gi 4/24
show bfd neighbors detail
FTOS(config)# bfd enable
FTOSconfig)# interface gigabitethernet 2/1
FTOS(conf-if-gi-2/1)# ip address 2.2.2.2/24
FTOS(conf-if-gi-2/1)# bfd neighbor 2.2.2.1
Command Syntax
interface
ip address ip-address
show bfd neighbors
Up 100 100
shows more specific information about
R2: ACTIVE Role
2/1
fnC0038mp
Command Mode
CONFIGURATION
INTERFACE
, as shown in the example
3 C
Bidirectional Forwarding Detection (BFD) | 147