Dell Force10 S4810P Configuration Manual page 288

To re-allocate CAM space within the Ingress Layer 2 ACL partition on the entire system as shown in the
following example. :
Step Task
1 Re-allocate CAM space within the Ingress
Layer 2 ACL partition.
2 Save the running-configuration.
3 Verify that FTOS will write the new CAM
configuration to the CAM on the next boot.
4 Reload the system.
FTOS(conf)#do show cam-l2acl | find "Line card 1"
-- Line card 1 --
Sysflow
L2Acl
Pvst
Qos
L2pt
Frrp
[output omitted]
FTOS(conf)#cam-l2acl system-flow 100 l2acl 0 p 0 q 0 l 0 f 0
FTOS(conf)#do show cam-l2acl | find "Line card 1"
-- Line card 1 --
Sysflow
L2Acl
Pvst
Qos
L2pt
Frrp
[output omitted]
FTOS(conf)#do copy run start
File with same name already exist.
Proceed to copy the file [confirm yes/no]: yes
!
8676 bytes successfully copied
02:00:49: %RPM0-P:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by default
FTOS(conf)#do show cam-l2acl | find "Line card 1"
-- Line card 1 --
Sysflow
L2Acl
Pvst
Qos
L2pt
Frrp
288
| Content Addressable Memory (CAM)
Current Settings(in percent)
: 6
: 14
: 50
: 12
: 13
: 5
Current Settings(in percent)
: 6
: 14
: 50
: 12
: 13
: 5
Current Settings(in percent)
: 6
: 14
: 50
: 12
: 13
: 5
Command Syntax
cam-l2acl
copy running-config startup-config
show cam-l2acl
reload
Next Boot(in percent)
100
5
5
5
5
5
Command Mode
CONFIGURATION
EXEC Privilege
EXEC Privilege
EXEC Privilege