Dell Force10 S4810P Configuration Manual page 343

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

Figure 13-16. show interface DCBx detail for ieee Command Example

FTOS(conf-if-te-0/17-lldp)#do sho int te 2/12 dc d

E-ETS Configuration TLV enabled

R-ETS Recommendation TLV enabled

P-PFC Configuration TLV enabled

F-Application priority for FCOE enabled

I-Application priority for iSCSI enabled

------------------------------------------------------------------------------------------

Interface TenGigabitEthernet 2/12

Remote Mac Address 00:01:e8:8a:df:a0

Port Role is Manual

DCBx Operational Status is Enabled

Is Configuration Source? FALSE

Local DCBx Compatibility mode is IEEEv2.5

Local DCBx Configured mode is IEEEv2.5

Peer Operating version is IEEEv2.5

Local DCBx TLVs Transmitted: ERPFi

1 Input PFC TLV pkts, 2 Output PFC TLV pkts, 0 Error PFC pkts

0 PFC Pause Tx pkts, 0 Pause Rx pkts

1 Input ETS Conf TLV Pkts, 1 Output ETS Conf TLV Pkts, 0 Error ETS Conf TLV Pkts

1 Input ETS Reco TLV pkts, 1 Output ETS Reco TLV pkts, 0 Error ETS Reco TLV Pkts

e-ETS Configuration TLV disabled

r-ETS Recommendation TLV disabled

p-PFC Configuration TLV disabled

f-Application Priority for FCOE disabled

i-Application Priority for iSCSI disabled

Data Center Bridging (DCB) | 343

Troubleshooting