Assign A Static Ipv6 Route - Dell Force10 S4810P Configuration Manual

One of the existing IPv6 addresses must be deleted before a new IPv6 address can be configured.
Command Syntax
ipv6 address
ipv6 address/mask

Assign a Static IPv6 Route

IPv6 Static Routes are supported on platforms
Use the command to configure IPv6 static routes.
ipv6 route
Command Mode
CONFIG-INTERFACE
IPv6 addresses are normally written as eight groups of four hexadecimal
digits, where each group is separated by a colon (:). Omitting zeros is accepted
as described in Addressing
c e s
Purpose
Enter the IPv6 Address for the device.
: x:x:x:x::x
ipv6 address
: prefix length 0 to 128
mask
earlier in this chapter.
IPv6 Routing | 553