Create A Virtual Stack Unit On An S-Series Stack; Display Information About An S-Series Stack - Dell Force10 S4810P Configuration Manual

Message 1 Renumbering the Stack Manager
Renumbering master unit will reload the stack.
WARNING: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]: yes

Create a Virtual Stack Unit on an S-Series Stack

Use virtual stack units to configure ports on the stack before adding a new unit.
Task
Create a virtual stack unit.

Display Information about an S-Series Stack

Task
Display for stack-identity, status, and
hardware information on every unit in a
stack. See the example below.
Display most of the information in
, but in a more convenient tabular
system
form. See the example below.
Display the same information in
, but only for the specified unit. See
system
the example below.
Display topology and stack link status for
the entire stack. The available options
separate the
show system stack-port
output into topology information from link
status information. See the example below.
Display information about an S4810 stack using the
Force10#show system
Stack MAC : 00:01:e8:8a:df:e6
Reload Type : normal-reload
-- Unit 0 --
Unit Type
Status
Next Boot
Required Type
Current Type
Master priority : 0
Hardware Rev
Num Ports
Up Time
FTOS Version
Jumbo Capable
POE Capable
990
| Stacking
show
show
: Management Unit
: online
: online
: S4810 - 52-port GE/TE/FG (SE)
: S4810 - 52-port GE/TE/FG (SE)
: 3.0
: 64
: 57 min, 0 sec
: 8-3-7-13
: yes
: no
Command Syntax
stack-unit provision
Command Syntax
show system
show system brief
show system stack-unit
show system stack-ports
show system
Command Mode
CONFIGURATION
[ | ]
status topology
command.
Command Mode
EXEC Privilege
EXEC Privilege
EXEC Privilege
EXEC Privilege