Specify Collectors
The
sflow collector
forwarded. The user can specify up to two sFlow collectors. If two Collectors are specified, the samples are
sent to both.
Collection through Management interface is supported on platform:
Command Syntax
sflow collector ip-address
agent-addr ip-address
[
max-datagram-size number
[
max-datagram-size number
Polling Intervals
The
sflow polling-interval
number of seconds between successive samples of counters to be sent to the collector. This command
changes the global default counter polling (20 seconds) interval. You can configure an interface to use a
different polling interval.
The polling interval can be configured globally (in CONFIGURATION mode) or by interface (in
INTERFACE mode) by executing the interval command:
.
Command Syntax
sflow polling-interval
interval value
Sampling Rate
Sampling Rate
The sFlow sampling rate is the number of packets that are skipped before the next sample is taken. sFlow
does not have time-based packet sampling.
940
|
sFlow
command allows identification of sFlow Collectors to which sFlow datagrams are
Command Mode
CONFIGURATION
[
number
] ] |
]
command configures the polling interval for an interface in the maximum
Command Mode
CONFIGURATION or
INTERFACE
is supported on platform
Usage
Identify sFlow collectors to which sFlow datagrams
are forwarded.
Default UDP port: 6343
Default max-datagram-size: 1400
Usage
Change the global default counter polling interval.
interval value—in seconds.
Range: 15 to 86400 seconds
Default: 20 seconds
e
t
e
.