Debug Layer 2 Protocol Tunneling; Provider Backbone Bridging - Dell Force10 S4810P Configuration Manual

Debug Layer 2 Protocol Tunneling

Task
Display debugging information for L2PT.

Provider Backbone Bridging

Provider Backbone Bridging
IEEE 802.1ad—Provider Bridges amends 802.1Q—Virtual Bridged Local Area Networks so that service
providers can use 802.1Q architecture to offer separate VLANs to customers with no coordination between
customers, and minimal coordination between customers and the provider.
802.1ad specifies that provider bridges operating Spanning Tree use a reserved destination MAC address
called the Provider Bridge Group Address, 01-80-C2-00-00-08, to exchange BPDUs instead of the Bridge
Group Address, 01-80-C2-00-00-00, originally specified in 802.1Q. Only bridges in the service provider
network use this destination MAC address so these bridges treat BPDUs originating from the customer
network as normal data frames, rather than consuming them.
The same is true for GVRP. 802.1ad specifies that provider bridges participating in GVRP use a reserved
destination MAC address called the Provider Bridge GVRP Address, 01-80-C2-00-00-0D, to exchange
GARP PDUs instead of the GVRP Address, 01-80-C2-00-00-21, specified in 802.1Q. Only bridges in the
service provider network use this destination MAC address so these bridges treat GARP PDUs originating
from the customer network as normal data frames, rather than consuming them.
Provider Backbone Bridging through IEEE 802.1ad eliminates the need for tunneling BPDUs with L2PT
and increases the reliability of provider bridge networks as the network core need only learn the MAC
addresses of core switches, as opposed to all MAC addresses received from attached customer devices.
Task
Use the Provider Bridge Group address
as the destination MAC address in
BPDUs. The xstp keyword applies this
functionality to STP, RSTP, and MSTP;
this functionality is not available for
PVST+.
is supported only on platforms:
Command Syntax
bpdu-destination-mac-address
provider-bridge-group
Command Syntax
debug protocol-tunnel
c s
[ | ]
stp gvrp
Command Mode
EXEC Privilege
Command Mode
CONFIGURATION
Service Provider Bridging | 933