Dell Force10 S4810P Configuration Manual page 344

Figure 13-17. show interface DCBx detail for legacy cee Command Example
FTOS(conf-if-te-0/17-lldp)#do sho int te 1/14 dc d
E-ETS Configuration TLV enabled
R-ETS Recommendation TLV enabled
P-PFC Configuration TLV enabled
F-Application priority for FCOE enabled
I-Application priority for iSCSI enabled
------------------------------------------------------------------------------------------
Interface TenGigabitEthernet 1/14
Remote Mac Address 00:01:e8:8a:df:a0
Port Role is Auto-Upstream
DCBx Operational Status is Enabled
Is Configuration Source? FALSE
Local DCBx Compatibility mode is CEE
Local DCBx Configured mode is CEE
Peer Operating version is CEE
Local DCBx TLVs Transmitted: ErPFi
Local DCBx Status
-----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 1
Acknowledgment Number: 1
Protocol State: In-Sync
Peer DCBx Status:
----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 1
Acknowledgment Number: 1
Total DCBx Frames transmitted 994
Total DCBx Frames received 646
Total DCBx Frame errors 0
Total DCBx Frames unrecognized 0
Table 13-5. show interface DCBx detail Command Description
Field
Interface
Port-Role
DCBx Operational Status
Configuration Source
344
| Data Center Bridging (DCB)
e-ETS Configuration TLV disabled
r-ETS Recommendation TLV disabled
p-PFC Configuration TLV disabled
f-Application Priority for FCOE disabled
i-Application Priority for iSCSI disabled
Description
Interface type with chassis slot and port number.
Configured DCBx port role: auto-upstream, auto-downstream, config-source,
or manual.
Operational status (enabled or disabled) used to elect a configuration source
and internally propagate a DCB configuration. The DCBx operational status is
the combination of PFC and ETS operational status.
Specifies whether the port serves as the DCBx configuration source on the
switch: true (yes) or false (no).