Configure Ftp Client Parameters - Dell Force10 S4810P Configuration Manual

To configure FTP server parameters, use any or all of the following commands in the CONFIGURA TION
mode:
Command Syntax
ftp-server topdir
dir
ftp-server username
password [
encryption-type
password
Note: You cannot use the
configured.
To view the FTP configuration, use the

Configure FTP client parameters

To configure FTP client parameters, use the following commands in the CONFIGURATION mode:
Command Syntax
ip ftp source-interface
ip ftp password
password
ip ftp username
name
To view FTP configuration, use the
shown in the example for
64
| Management
Command Mode
CONFIGURATION
CONFIGURATION
username
]
change directory (cd)
Command Mode
CONFIGURATION
interface
CONFIGURATION
CONFIGURATION
show running-config ftp
Enable FTP
Purpose
Specify the directory for users using FTP to reach the
system.
The default is the internal flash directory.
Specify a user name for all FTP users and configure either
a plain text or encrypted password. Configure the
following optional and required parameters:
• username: Enter a text string
•
encryption-type:
encrypted text.
•
password:
command until
show running-config ftp
Purpose
Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a loopback interface, enter the keyword loopback
followed by a number between 0 and 16383.
• For a port channel interface, enter the keyword
port-channel followed by a number from 1 to 255 for
TeraScale and ExaScale, 1 to 32 for EtherScale.
• For a SONET interface, enter the keyword sonet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed
by a number from 1 to 4094.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
Configure a password.
Enter username to use on FTP client.
command in the EXEC privilege mode as
server.
Enter 0 for plain text or 7 for
Enter a text string.
ftp-server topdir has been
command in EXEC privilege mode.
followed by the slot/port information.