Clear Ipv6 Routes - Dell Force10 S4810P Configuration Manual

Figure 25-10. Command Example:
FTOS#show run int gi 2/2
!
interface GigabitEthernet 2/2
no ip address
ipv6 address 3:4:5:6::8/24
shutdown
FTOS#

Clear IPv6 Routes

Use the clear IPv6 route command to clear routes from the IPv6 routing table.
Command Syntax
clear ipv6 route
}
prefix-length
560
| IPv6 Routing
{ |
*
ipv6 address
show running-config interface
Command Mode Purpose
EXEC Clear (refresh) all or a specific routes from the IPv6
routing table.
: all routes
*
ipv6 address
mask
IPv6 addresses are normally written as eight groups of four hexadecimal
digits, where each group is separated by a colon (:). Omitting zeros is
accepted as described in Addressing
: x:x:x:x::x
: prefix length 0-128
earlier in this chapter.