Dell Force10 S4810P Configuration Manual page 886

To assign commands and passwords to a custom privilege level, you must be in privilege level 15 and use
these commands in the following sequence in the CONFIGURATION mode:
Step Command Syntax
1
username name
access-list-name
[
nopassword | password
[
encryption-type
2
enable password
[
encryption-mode
3
privilege mode
reset command
To view the configuration, use the
Figure 43-2
commands and all
and, by default, found in the CONFIGURATION mode, you must also assign the launch command for the
CONFIGURATION mode,
886
| Security
[
access-class
] [ ]
privilege level
] ]
password
[ ]
level level
]
password
{ |
level level command
}
show running-config
is an example of a configuration to allow a user "john" to view only the EXEC mode
r commands. Since the
snmp-serve
, to the same privilege level as the
configure
Command Mode Purpose
CONFIGURATION Assign a user name and password. Configure the
optional and required parameters:
•
•
•
•
•
•
CONFIGURATION Configure a password for privilege level.
Configure the optional and required parameters:
•
•
•
To change only the password for the enable
command, configure only the
parameter.
CONFIGURATION Configure level and commands for a mode or
reset a command's level. Configure the
following required and optional parameters:
•
•
•
•
command in the EXEC Privilege mode.
snmp-server
Enter a text string (up to 63
name:
characters).
access-class access-list-name:
name of a configured IP ACL.
range: 0 to 15.
privilege level
Do not require the user to enter
nopassword:
a password.
Enter 0 for plain text or 7 for
encryption-type:
encrypted text.
Enter a string.
password:
Specify a level 0 to 15. Level 15
level level:
includes all levels.
Enter 0 for plain text or 7 for
encryption-type:
encrypted text.
Enter a string up to 25 characters
password:
long.
password
Enter a keyword for the modes (exec,
mode:
configure, interface, line, route-map, router)
range: 0 to 15. Levels 0, 1 and 15
level level
are pre-configured. Levels 2 to 14 are
available for custom configuration.
A FTOS CLI keyword (up to 5
command:
keywords allowed).
Return the command to its default
reset:
privilege mode.
commands are "enable" level commands
commands.
snmp-server
Enter the