Dell Force10 S4810P Configuration Manual page 204

Step Command Syntax
5
neighbor ip-address peer-group
peer-group-name
6 neighbor {ip-address | peer-group
name} remote-as as-number
After you create a peer group, you can use any of the commands beginning with the keyword
configure that peer group.
When you add a peer to a peer group, it inherits all the peer group's configured parameters.
A neighbor
• neighbor advertisement-interval
• neighbor distribute-list out
• neighbor filter-list out
• neighbor next-hop-self
• neighbor route-map out
• neighbor route-reflector-client
• neighbor send-community
A neighbor may keep its configuration after it was added to a peer group if the neighbor's configuration is
more specific than the peer group's, and the neighbor's configuration does not affect outgoing updates.
Note: When you configure a new set of BGP policies for a peer group, always reset the peer group by
entering the clear ip bgp peer-group peer-group-name command in EXEC Privilege mode.
Use the
show config
configuration. When you create a peer group, it is disabled (
a peer group (zanzibar).
204
| Border Gateway Protocol
become part of a peer group if it has any of the following commands are configured:
cannot
command in the CONFIGURATION ROUTER BGP mode to view the
Command Mode
CONFIG-ROUTER-BGP
CONFIG-ROUTER-BGP
To add an external BGP (EBGP) neighbor, configure the as-number
parameter with a number different from the BGP as-number configured
in the router bgp as-number command.
To add an internal BGP (IBGP neighbor, configure the as-number
parameter with the same BGP as-number configured in the router bgp
as-number command.
shutdown
Purpose
Add an enabled neighbor to the peer group.
Add a neighbor as a remote AS.
Formats:
IP Address A.B.C.D
Peer-Group Name16 characters
AS-number: 0-65535 (2-Byte) or
1-4294967295 | 0.1- 65535.65535 (4-Byte)
or 0.1-65535.65535 (Dotted format)
). Figure 9-19 shows the creation of
to
neighbor