Is-Is Metric Styles; Configure Metric Values - Dell Force10 S4810P Configuration Manual

Command Syntax
debug isis update-packets
FTOS displays debug messages on the console. Use the
mode to view which debugging commands are enabled.
Enter the keyword no followed by the debug command to disable a specific debug command. For example,
to disable debugging of IS-IS updates, enter
Enter
no debug isis
Enter
undebug all

IS-IS Metric Styles

The following sections provide additional information on IS-IS Metric Styles.
• IS-IS Metric Styles on page 595
• Configure Metric Values on page 595
FTOS supports the following IS-IS metric styles:
• narrow (supports only type, length, and value (TLV) up to 63)
• wide (supports TLV up to 16777215)
• transition (supports both narrow and wide and uses a TLV up to 63)
• narrow transition (accepts both narrow and wide and sends only narrow or old-style TLV)
• wide transition (accepts both narrow and wide and sends only wide or new-style TLV)

Configure Metric Values

The following topics are covered in this section:
• Maximum Values in the Routing Table on page 596
• Changing the IS-IS Metric Style in One Level Only on page 596
• Leaking from One Level to Another on page 598
Command Mode
[ ] EXEC Privilege
interface
to disable all IS-IS debugging.
to disable all debugging.
Purpose
View sent and received LSPs.
To view specific information, enter one of the
following optional parameters:
•
interface:
information to view IS-IS information on that
interface only.
show debugging
no debug isis updates-packets
Intermediate System to Intermediate System | 595
Enter the type of interface and slot/port
command in EXEC Privilege
.