Dell Force10 S4810P Configuration Manual page 66

•
enable
• —Prompt for the e password you assigned to the terminal line. You must configure a password for
line
the terminal line to which you assign a method list that contains the
Configure a password using the command password from LINE mode.
• —Prompt for the the system username and password.
local
• —Do not authenticate the user.
none
•
radius
•
tacacs+
To configure authentication for a terminal line:
Step Task
1 Create an authentication method list.
You may use a mnemonic name or
use the keyword
authentication method for terminal
lines is
local
list is empty.
2 Apply the method list from Step 1 to
a terminal line.
3 If you used the line authentication
method in the method list you
applied to the terminal line,
configure a password for the terminal
line.
In the example below, VTY lines 0-2 use a single authentication method,
FTOS(conf)#aaa authentication login myvtymethodlist line
FTOS(conf)#line vty 0 2
FTOS(config-line-vty)#login authentication myvtymethodlist
FTOS(config-line-vty)#password myvtypassword
FTOS(config-line-vty)#show config
line vty 0
password myvtypassword
login authentication myvtymethodlist
line vty 1
password myvtypassword
login authentication myvtymethodlist
line vty 2
password myvtypassword
login authentication myvtymethodlist
FTOS(config-line-vty)#
66
| Management
—Prompt for the enable password.
—Prompt for a username and password and use a RADIUS server to authenticate.
—Prompt for a username and password and use a TACACS+ server to authenticate.
. The default
default
, and the method
default
Command Syntax
aaa authentication login {
default } [ ] [
method-1 method-2
[ ] [ ] [
method-4 method-5 method-6
login authentication {
method-list-name
default }
password
authentication method.
line
Command Mode
|
method-list-name
CONFIGURATION
] [ ]
method-3
]
|
CONFIGURATION
LINE
.
line