Directed Broadcast - Dell Force10 S4810P Configuration Manual

Command Syntax
management route ip-address mask
{
forwarding-router-address
ManagementEthernet slot/port
To view the configured static routes for the management port, use the
in the EXEC privilege mode.
FTOS#show ip route static
Destination
-----------
S 2.1.2.0/24
S 6.1.2.0/24
S 6.1.2.2/32
S 6.1.2.3/32
S 6.1.2.4/32
S 6.1.2.5/32
S 6.1.2.6/32
S 6.1.2.7/32
S 6.1.2.8/32
S 6.1.2.9/32
S 6.1.2.10/32
S 6.1.2.11/32
S 6.1.2.12/32
S 6.1.2.13/32
S 6.1.2.14/32
S 6.1.2.15/32
S 6.1.2.16/32
S 6.1.2.17/32
S 11.1.1.0/24
--More--

Directed Broadcast

By default, FTOS drops directed broadcast packets destined for an interface. This default setting provides
some protection against Denial of Service (DOS) attacks.
To enable FTOS to receive directed broadcasts, use the following command in the INTERFACE mode:
Command Syntax
ip directed-broadcast
To view the configuration, use the
522
| IPv4 Routing
Command Mode
CONFIGURATION
|
}
Gateway
-------
Direct, Nu 0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
via 6.1.20.2, Te 5/0
Direct, Nu 0
Direct, Lo 0
Command Mode
INTERFACE
show config
Purpose
Assign a static route to point to the management
interface or forwarding router.
show ip management-route
Dist/Metric Last Change
----------- -----------
Purpose
Enable directed broadcast.
command in the INTERFACE mode.
command
0/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
0/0 00:02:30