Configure Port-Based Rate Limiting - Dell Force10 S4810P Configuration Manual

Figure 39-5. Displaying your Rate Policing Configuration
FTOS#show interfaces gigabitEthernet 1/2 rate police
Rate police 300 (50) peak 800 (50)
Traffic Monitor 0: normal 300 (50) peak 800 (50)
Out of profile yellow 23386960 red 320605113
Traffic Monitor 1: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 2: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 3: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 4: normal NA peak NA
Out of profile yellow 0 red 0

Configure Port-based Rate Limiting

Configure Port-based Rate Limiting
FTOS Behavior: On the C-Series and S-Series, rate shaping is effectively rate limiting because of its smaller
buffer size.
Rate limit egress traffic on an interface using the command rate limit from INTERFACE mode, as shown
in Figure
packets are rate limited.
Figure 39-6. Rate Limiting Egress Traffic
FTOS#config t
FTOS(conf)#interface gigabitethernet 1/0
FTOS(conf-if)#rate limit 100 40 peak 150 50
FTOS(conf-if)#end
FTOS#
Display how your rate limiting configuration affects traffic using the keyword
show interfaces
822
| Quality of Service (QoS)
39-6. If the interface is a member of a VLAN, you may specify the VLAN for which egress
, as shown in Figure
is supported only on platform
39-7.
e
with the command
rate limit